Wednesday, March 15, 2023

Rubber Band Smart Phone Holder

 I found this on thingiverse Rubber Band Smart Phone Holder. It is Really a tripod for your phone. It is a simple print. Of course I did have to update my build plate as it was having a hard time sticking. That has always been fixed by replacing the magnetic build plate surface. As they do get worn out over time.





Rather then crowd the print I did it in 3 separate prints. The three legs in one print. The phone holder in another and the top of the legs as a third. I used M4*12 Screws and M4 nuts to hold it together. I was a little nervous about the width of the tripod leg holder but the screws pull it all in and they are tight enough not to move but not so tight that I can't change the position.






Thanks for looking!

Jim