Sunday, February 9, 2020

New tool

I picked up a Neje laser engraver to sign my work. This will be much improved over using my inkjet printer and wax paper. That was always prone to slipping and being smudged. Which I then would have to sand off. This laser engraver can do just shy of 6" square.  I made a few test runs tonight trying to figure out the best settings for power of the laser and speed. I have a good set of numbers for slow printing. I will see if I can find anything that will work under the fast mode.




This is so much better and easier then using my inkjet with wax paper.

Jim