Monday, January 28, 2019

Groot AIR Plant pot

I found this in thingiverse  I had blue already loaded up and pretty new so I printed it in blue. I used cura to slice it.  This took about 12 hours to print. Video is a timelapse from octoprint I run on a Raspberry PI connected to the printer to give my 3d printer a web front end to print from and monitor.




Here is a picture with an air plant in it.


Sunday, January 20, 2019

Another set

I've never actually ever have gone back and did a pattern more than once. I promised to make one of these for my wife since I was stack cutting thse at Christmas and I had too many in the pile and I lost a bunch of them when I pushed too hard against the blade. When you do that the blade will curve and when that happens you end up cutting at an angle. For my stack it ment the lower layers where ruined from the flex. So I have done a couple more of these. I was able to stack these as just two and was able to complete the cuts in a signle day. Had a nice warm day here today so it was a good day to cut.



My usual Watco Natural Danish Oil.

I need to figure out what I am doing for the 2019 NC State Fair and get that done earlier then in previous years. Still deciding. I have a bunch of patterns just have to decide.

Tahnks for looking
Jim